NMK931 Watch Watch Coffret: Finition en acier

The case looks amazing, if this is a style you are going for I can recommend the finishing. It is not for beginners though as others have commented. The crystal is difficult to place, I found it easiest to set with a small anvil on the press, going around the edges little by little. I've switched around the chapter ring a few times and can now get the crystal seated every time with this method.

My first time trying Namoki, sadly I didn't take P.S. (Tadley, GB) and René K. (Nieuwaal, NL) reviews into consideration when buying the case, the crystal was just impossible to fit, I struggled with it for around an hour and a half! the crystal was never flush I must have popped in and out like 10 times. I left it uneven for like a week so I could try again today and after another half an hour of trying the crystal broke... Maybe removing the crystal gasket would have made it easier to install? I guess I'll never know :( . Such a shame bc the case shape is so beautiful! I was even planning to buy more stuff from Namoki but now I am not so sure

Nice design. buy for future built.

Not sure if this is due to chapter rings or case but the chapter rings move around slightly in the case. Crystal and Dial are on as tight as possible

Never before have I been disappointed in the quality of parts at namokiMODS. However, in my opinion, the NMK932 Field Watch Case Bundle is not recommended due to quality issues. I like the look, size and finish off the case, but should have taken the review from P.S. (Tadley, GB) to heart. The crown tube is really too long and gets in the way of the dial. Such that the dial will be damaged when placed. That in itself can be remedied. I used a grinding machine to grind back the crown tube, after which the movement with the dial could be placed normally. Not what I expected, but ok, as a watch modder you sometimes have to go the extra mile.
The placement of the crystal turned out to be worse. Like P.S. (Tadley, UK) experienced, it proved impossible for me to install it flush. I own two good glass presses and have quite a bit of experience with them, but no matter what I tried, the glass was never completely flat. Since I edited the parts and because I see good reviews as well, I take my loss. This watch case is clearly not for me and will end up in the bin.